22mm momentary pushbutton with Green LED ring.
- 12V Green LED
- Presoldered wiring to be used with SmartEVSE v2.2
- Waterproof IP65, with rubber ring.
- Wiring 45cm long.
- Stainless steel.
Use this pushbutton to stop charging the EV, and switch between Smart charging and Solar charging.
The green led will light up in various ways to indicate different charging states:
Off |
Access denied (Configurable in menu) |
Dimmed Green |
Unconnected, Ready to Charge |
Bright Green |
Connected, Ready to Charge |
Fading in/out |
Smart Charging |
Slow Fading in/out |
Solar Charging |
Short blinking |
Charging Stopped, please remove charging cable. Waiting for Solar power (Solar mode) |
Fast blinking |
Error (Communication Error or Temperature to high) |
The use of this pushbutton/status indicator requires a SmartEVSE v2.1 with software version 2.04 or higher.
Future firmware versions might change the behaviour of the LED and pushbutton.
SmartEVSE v2.0 can not drive the 12V LED directly, but does respond to the pushbutton.