Smart charge controller for electric vehicles
The SmartEVSE can dynamically adjust the maximum power the Electric Vehicle will charge with. It supports a charging socket with locking actuator, or fixed charge cable. Up to eight SmartEVSE's can be connected together to allow for load balancing between charging stations.
Iskra 4 pole 32A Contactor.
Specifications:
Sensorbox 2 will measure the current (and direction of current flow) on three phases, and will send this data to the SmartEVSE controller.
Sensorbox plus will measure the current (and direction of current flow) on three phases, and will send this data to the SmartEVSE controller.
There are 17 products.
Smart charge controller for electric vehicles
The SmartEVSE can dynamically adjust the maximum power the Electric Vehicle will charge with. It supports a charging socket with locking actuator, or fixed charge cable. Up to eight SmartEVSE's can be connected together to allow for load balancing between charging stations.
Sensorbox plus will measure the current (and direction of current flow) on three phases, and will send this data to the SmartEVSE controller.
Sensorbox 2 will measure the current (and direction of current flow) on three phases, and will send this data to the SmartEVSE controller.
Iskra 2 pole 32A Contactor.
Specifications:
Iskra 4 pole 32A Contactor.
Specifications:
22mm momentary pushbutton with tri colour (RGB) LED ring.
DIN rail enclosure, IP65 for use with SmartEVSE, contactors, terminal blocks, etc.
Type 2 Charging Socket with 60cm cables and locking actuator.
This residual current monitor will detect DC residual currents in 50Hz/60Hz AC installations.
It's primarily intended for use in Electric Vehicle charging stations to disconnect the supply to the Electric Vehicle under a DC residual fault current condition.
RFID reader 13.56 MHz Mifare
Two status Leds (Red/Green)
Can be connected to the SmartEVSE v3
Reader can be mounted with the M12 nut.
The EtherLCD upgrade adds a Ethernet (10/100) interface to your SmartEVSE v3 controller.
- Easy to install yourself — you only need to move the main board into the new enclosure.
- Works with all SmartEVSE v3 controllers.
Waterproof RFID reader 13.56 MHz Mifare
Two status Leds (Red/Green)
Can be connected to the SmartEVSE v3
Reader can be mounted with the M12 nut.